High Impact Factor : 4.396 icon | Submit Manuscript Online icon |

Design and Manufacturing of Special Purpose Subsystems for Drilling and Tapping Operations

Author(s):

P. P. Harane , D.K.T.E. Society?s Textile and Engineering Institute, Ichalkaranji. India; P. N. Gore, D.K.T.E. Society?s Textile and Engineering Institute, Ichalkaranji. India

Keywords:

Tapping Operations, Manufacturing of Special Purpose Subsystems

Abstract

The growth of mechanical industries depends on its productivity & quality. The decision making of company is largely based on the motives of improving traditional manufacturing practices to result in to major advantages like, reduced manufacturing lead times, fool-proofing of methods of processing & consistent results on a long run. In case of mass production where job variety is less and quantity produced is large, it is very important to produce faster job production. This paper includes case study and comparison of component using traditional radial drilling machine and SPM for drilling and tapping operations. The special purpose machine is used for drilling two holes of Ø5 and M6x1 tapping for those two holes. The following studies are carried out 1. Time saved by component loading and unloading on indexing unit, 2. Increase qualitative and quantitative productivity, 3. Minimum human intervention, 4. Minimum rejection due to automatic control, 5. Enhance the profit of organization.

Other Details

Paper ID: IJSRDV3I120250
Published in: Volume : 3, Issue : 12
Publication Date: 01/03/2016
Page(s): 462-465

Article Preview

Download Article