High Impact Factor : 4.396 icon | Submit Manuscript Online icon |

Evaluation the Effect of Machining Parameters for Surface Finish using Turning of Aluminium 6063

Author(s):

Sudhir Kumar , TERII, Kurukshetra; Pardeep Kumar, TERII, Kurukshera; Shyam Singh, GBNGP, Nilokheri

Keywords:

Taguchi Design, Orthogonal Array, Turning, Cutting Speed, Feed, Ra, Surface Finish

Abstract

Turning is a basic operation for various industries & surface finish is very essential for the components to be machined therefore to optimize the surface finish various parameters affecting turning for the optimum condition. Surface finish is affected by machining parameters, tool material, tool type and cutting fluids etc. The parameter influence most are cutting speed, depth of cut , feed, geometry of cutting tool like principle cutting edge angle ,rake angle, nose radius etc. In order to optimize the surface finish it is very necessary to control various parameters. In the turning operation the different values of cutting parameters, cutting speed (45, 90,140,330), feed rate (.1, 0.22, 0.44, 0.68 mm/rev), depth of cut (.5, 1, 1.5,2 mm) are selected. Surface finish is largely influenced by Feed then Speed then DOC. Surface finish shows a decreasing trend with increasing Feed. Surface finish is minimum at lowest revolving speed. Surface finish is minimum at lowest depth of cut.

Other Details

Paper ID: IJSRDV4I50468
Published in: Volume : 4, Issue : 5
Publication Date: 01/08/2016
Page(s): 764-766

Article Preview

Download Article