Remotely Controlling of the Parameters Using LabVIEW and W5300 via Ethernet Interface

this application will be used to control various parameters such as Gain, Filter Frequency etc. in Electronics and Data Acquisition System. We will be using Ethernet Interface for remotely controlling and LabVIEW software for user interface. The TCP protocol is used for the data communication, which is one of the important features in DAQ systems. The prototype application has been designed using the WIZ830MJ Ethernet controller module which consists of the W5300 SoC chip, which is interfaced with FPGA. The Xilinx’s ISE is used to write a VHDL code in FPGA. The FPGA is programmed in such manner using VHDL to set the registers of W5300 to implement protocol in it and data communication for the electronics and data acquisition board. The prototype application has been implemented and tested in the lab. The paper will describe about the hardware and the software for the prototype application.