Investigation on Surface Roughness for End milling on Aluminium Alloy 6061-T6 for Different Parameters. |
Author(s): |
Parth Piyushbhai Shah , LDRP-ITR COLLEGE; Assi. Prof. Ankit Darji, LDRP-ITR COLLEGE |
Keywords: |
Surface Finish, Surface Roughness, Minitab, End Milling |
Abstract |
A set of experimental runs done to get knowledge about the surface quality for the end-milling process have been performed. The purpose of this research is to have a good understanding of the effects of spindle speed, cutting feed rate and depth of cut on the surface roughness and also to build a regression equation. Such an understanding can give idea into the problems of controlling the finish of machined surfaces when the process parameters are adjusted to have a good surface finish. This study has considered the effect of spindle speed, cutting feed rate and depth of cut for predicting the surface roughness values and also interactions between the two variables. |
Other Details |
Paper ID: IJSRDV4I10762 Published in: Volume : 4, Issue : 1 Publication Date: 01/04/2016 Page(s): 889-893 |
Article Preview |
|
|