A Survey and Review on Grid Interconnection of Solar Photovoltaic System for 3 Phase Distribution System with Eliminate Total Harmonic Distortion

A photovoltaic system converts sunlight into electricity. The basic device of a photovoltaic system is the photovoltaic cell. Cells may be grouped to form panels or modules. Panels can be grouped to form large photovoltaic arrays the development of a method for the mathematical modeling of photovoltaic arrays. The objective of the method is to fit the mathematical I-V equation to the I-V curve of the practical array. The method obtains the parameters of the I-V equation by using the following nominal information from the array datasheet: open-circuit voltage, short-circuit current, maximum output power, voltage and current. The modeling and simulation of photovoltaic arrays that are single panels or modules composed of several interconnected basic photovoltaic cells. A photovoltaic system converts sunlight into electricity. The basic device of a photovoltaic system is the photovoltaic cell. Cells may be grouped to form panels or modules. Panels can be grouped to form large photovoltaic arrays the development of a method for the mathematical modeling of photovoltaic arrays Large arrays composed of several panels may be modeled in the same way, provided that the equivalent parameters (short-circuit current, open-circuit voltage) are properly inserted in the modeling process. As a result, the equivalent parameters (resistances, currents, etc) of the association are obtained. Generally experimental data are available only for commercial low-power modules and this is the reason why this paper has chosen to deal with small arrays. The term array has been used throughout this paper to mean small commercial photovoltaic modules or panels. The MATLAB model shows how to model and simulate large arrays composed of several series or parallel module and in this work we simulate solar Photovoltaic array with connected with &without LC filter. In future there is a need to develop a model that can perform very accurate. System-wide simulations involving all the individual subsystems that constitute a photovoltaic system. We use neural network models can be built based on a portion of measurements and validated using a different subset of measurements. New maximum power point tracking algorithms can be developed and tested on this simulation test bed. Other renewable energy systems such as wind energy maybe modeled and a complete system with photovoltaic and wind energy may be developed and monitored.