A Review Paper on Optimization of Process Parameters on Wire Electrical Discharge Machining |
Author(s): |
| Mr. Nairut M. Shah , Aadishwar College of Technology �VENUS; Mr. Sagar Ramavat, Head Of Mechanical Department; Mr. Vikrant Mahajan, Assistant Professor; Ms. Bhavna Kori, lecturer |
Keywords: |
| Wire Electro Discharge Machining (WEDM) Material removal Rate (MRR), surface Roughness (SR), Taguchis orthogonal array, S/N Ratio, Wire Feed, Wire Tension |
Abstract |
|
Present study has been made to optimize of surface roughness and material removal rate in EN 24T steel. Two input parameters wire feed, wire tension were chosen as variable to study the process parameter. The analysis of variance (ANOVA) was carried out for study the effect of process parameters on process performance. In addition mathematical models have also been developed for response parameter. Properties of the machined surface have been examined by surface roughness tester. For the different values of the two input parameters developed L9 orthogonal array by taguchi method. The effect of each control factor on the performance measure will study individually using the plots of signal to noise ratio (S/N) The study demonstrates that the WEDM process parameters can be adjusted so as to achieve better metal removal rate and surface finish. |
Other Details |
|
Paper ID: IJSRDV7I20596 Published in: Volume : 7, Issue : 2 Publication Date: 01/05/2019 Page(s): 677-680 |
Article Preview |
|
|
|
|
