A Review Paper on Parametric Optimization of Electro Discharge Machining Process for MRR, Micro Hardness and Surface Roughness |
Author(s): |
| Patel Umesh K , LDRP ? ITR, Gandhinagar; Prof. Vidhya Nair, LDRP ? ITR, Gandhinagar |
Keywords: |
| E.D.M., Taguchi Technique, ANOVA, Surface Finish, MRR |
Abstract |
|
The Electro Discharge Machining is a widely accepted non-convection machining process. There are so many process parameters which are statistically affects the machining. Best combination of these parameters gives excellent result. For current research pulse on time, pulse off time, peak current and spark gap set voltage is selected to optimize material removal rate. Surface roughness and micro hardness is also optimizing for better result. The analysis is based on Response surface Methodology. |
Other Details |
|
Paper ID: IJSRDV3I30672 Published in: Volume : 3, Issue : 3 Publication Date: 01/06/2015 Page(s): 3200-3204 |
Article Preview |
|
|
|
|
