Designing of Screw Feeder in Batching System |
Author(s): |
| Ulkesh Solanki , Smt. Kashibai Navale College of Engineering; Amol Shroff, Smt. Kashibai Navale College of Engineering; Prashant Waghmare, Smt. Kashibai Navale College of Engineering; Tejas Kulkarni, Smt. Kashibai Navale College of Engineering; K.P. Agte , Smt. Kashibai Navale College of Engineering |
Keywords: |
| Screw Feeder, Pitch of Screw, Equivalent Capacity, Horse Power, Shaft Diameter |
Abstract |
|
This article gives brief information about designing of a screw feeder. Four free flowing and granular materials P, Q, R and S which are required to get feeded are taken into account for the designing. Flow rates of four materials are calculated based on the time limit allotted for feeding. Important parameters like screw diameter, pitch of screw, shaft diameter, screw length are computed. Power required for the motor to drive the screw is estimated and Geometries of screw feeder are included in this paper. |
Other Details |
|
Paper ID: IJSRDV3I30796 Published in: Volume : 3, Issue : 3 Publication Date: 01/06/2015 Page(s): 2375-2376 |
Article Preview |
|
|
|
|
