Optimization of End Milling Process Parameters on Surface Roughness of SS 420 by Taguchi Method |
Author(s): |
| Inderjeet Singh , BBSBEC Fatehgarh sahib; Dr. A.P.S. Sethi, BBSBEC Fatehgarh sahib |
Keywords: |
| End Milling, SS 420, SR, L-9, ANOVA |
Abstract |
|
The present work in this paper depicts the influence of different milling parameters spindle speed, feed rate and depth of cut. This investigation deals with the machining of SS 420 to optimize the process parameters and to minimize the surface roughness. The L9 orthogonal array is designed using Taguchi technique with three levels of each process parameters. The cutting operation of job was done by solid end mill four-flute cutter. A total of nine experimental run were carried out. Finally signal-to-Noise (S/N) ratio, Analysis of variance (ANOVA) and different plots developed by MINITAB 15 software were employed to study the effect of input parameters on Surface roughness (SR) and presented in this paper. |
Other Details |
|
Paper ID: IJSRDV3I60215 Published in: Volume : 3, Issue : 6 Publication Date: 01/09/2015 Page(s): 325-328 |
Article Preview |
|
|
|
|
