Automatic Serpentine Tube Bending Machine |
Author(s): |
| Chandrakant Balkrushna Jadhav , ADCET, Ashta; Digvijay Chudmunge, ADCET, Ashta; Rajvardhan Dalvi, ADCET, Ashta; Prafull Holkar, ADCET, Ashta; Akshay Dhanawade, ADCET, Ashta |
Keywords: |
| Bending, Defects, 3 Main Systems, Serpentine Tube, Automatic Bending |
Abstract |
|
The common method used to make a Condenser coil in India is by hand bending where the precision of the bend is dependent on the skill of the worker which is not always reliable as it leads to defects in bends like wrinkling, distortion on inner and outer side of the bends, wrong bend angle etc. We have worked very hard to provide a solution for this problem by designing an Automatic Tube Bending Machine which has negligible errors as compared to its manual counterparts. The machine is divided into 3 main systems which are bending system, feeding system and control system. The Bending system consists of 2 rollers mounted on two servo motors, the feeding system consists of two rollers powered by servo motor to feed the tube into the bending system and the Control System consists of Servo Drive and Programmable Logic Controller. |
Other Details |
|
Paper ID: IJSRDV5I21009 Published in: Volume : 5, Issue : 2 Publication Date: 01/05/2017 Page(s): 1121-1123 |
Article Preview |
|
|
|
|
