Modification of Trimtool Design |
Author(s): |
| Vivek P. Mugal , Dr. D. Y. Patil Institute of Technology, pimpri, pune-18; Anand Narasale, Dr. D. Y. Patil Institute of Technology, pimpri, pune-18; Akshay Vahile, Dr. D. Y. Patil Institute of Technology, pimpri, pune-18; Abhinav Patil, Dr. D. Y. Patil Institute of Technology, pimpri, pune-18; Prof. Rutukesh Bhosale, Dr. D. Y. Patil Institute of Technology, pimpri, pune-18 |
Keywords: |
| To minimize the rejection of components after trimming operation |
Abstract |
|
In casting process, as our component came out from mould it is still needed to finish to form as a final product. Casting still has unwanted projection like sprue, riser, runner, etc. In order to remove the above mentioned projection in just a single pass of cutting operation the die named as 'Trimming Die' is used. Die consist of two half namely upper half and lower half. Upper half is held into ram which is known as top plate and lower half is fixed on a table which is known as bottom plate. While component is getting trimmed there are issue related cutting. One of them is undercutting. We modify design which removes the problem related to shearing cause undercutting in the product. We successfully solve problem of undercutting and completely eliminate it. |
Other Details |
|
Paper ID: IJSRDV6I20529 Published in: Volume : 6, Issue : 2 Publication Date: 01/05/2018 Page(s): 741-744 |
Article Preview |
|
|
|
|
