Fabrication of Frictionless Electromagnetic Braking System |
Author(s): |
| S. Palanisamy , Muthayammal Engineering College, Rasipuram; S. Harikrishnan, Muthayammal Engineering College; M. Kannan, Muthayammal Engineering College; P. Durairaja, Muthayammal Engineering College; B. Gokul Kannan, Muthayammal Engineering College |
Keywords: |
| Braking System, Wheel, Electromagnet Coil, Dynamo, Battery, Frame, Belt, Wire, Chain, And Sprocket |
Abstract |
|
In recent days, braking is affected during rainy, winter seasons or certain places which creates a lot a safety issues regarding the wear and failure of brakes which creates uneconomic car maintenance. The response time or time lag between two consecutive braking is comparatively higher. Heat generation during braking is very high. To diminish these problems to some extent we introduce a new technology, Frictionless braking system. In this system an electromagnet is magnetized by a 12 Volt battery which is powered by a dynamo. An ON/OFF switch is used as an alternate to the brake pedal. Once the switch is ON the electromagnet gets magnetized and stop the motion of the vehicle with quick response. This system provides better response time for emergency situations and in general keeps the frictionless brake working longer and safer. |
Other Details |
|
Paper ID: IJSRDV7I10826 Published in: Volume : 7, Issue : 1 Publication Date: 01/04/2019 Page(s): 1089-1092 |
Article Preview |
|
|
|
|
