Roughness of Surfaces Worked During Milling with Changes in the Direction of Mills |
Author(s): |
| Astrit Shartari , Department Industrial Machinery, Faculty of Applied Engineering Sciences in Mitrovica, University of Prishtina, Republic of Kosovo.; Besim Hajra, Department Production and Automation, Faculty of Mechanical Engineering, University of Prishtina, Republic of Kosovo.; Ruzhdi Qerimi, Department Production and Automation, Faculty of Mechanical Engineering, University of Prishtina, Republic of Kosovo.; Shefqet Hyseni, Department Industrial Machinery, Faculty of Applied Engineering Sciences in Mitrovica, University of Prishtina, Republic of Kosovo.; Njazi Ujkani, Department Industrial Machinery, Faculty of Mechanical and Computer Engineering, University of Mitrovica �Isa Boletini�, Republic of Kosovo |
Keywords: |
| work surfaces, cutting tool, experiment, machine, processing regime, surface roughness |
Abstract |
|
The purpose of this paper is to measure the roughness of the working surfaces during milling for X210Cr12 steel and 17Mn4 steel (according to DIN). All the machine characteristics (used cutting regime), the factors affecting the surface roughness rate for these two types of steel, the performance of the measurements and the analysis of the results are given in this paper. |
Other Details |
|
Paper ID: IJSRDV7I90393 Published in: Volume : 7, Issue : 9 Publication Date: 01/12/2019 Page(s): 526-528 |
Article Preview |
|
|
|
|
