Design and Analysis Simplify to the id Fan Blade Bearing Assembly |
Author(s): |
| Vijayabaskar.L , CK College of Engineering & Technology; D.Ranjithkumar, CK College of Engineering & Technology; S.Mohanraj, CK College of Engineering & Technology; K.Kalaivanan, CK College of Engineering & Technology; S.Muthu, CK College of Engineering & Technology |
Keywords: |
| Bearing, Impeller, fixture, roller |
Abstract |
|
Our project is to design a fixture for assembling all parts present in the induced draft fan impeller. We absorbed the present method of assembling the various parts in the ID FAN and found out the following problems in it. (1) Delay in fitting the blade bearing shaft. (2) Heavy to lift to blade shaft because it weight about 50kg. (3) The height of the fan is too high to load various parts. To overcome this problems, we going to design a special fixture to assemble the parts. This make easier to load various components.it reduced the delay time and increases the productivity. |
Other Details |
|
Paper ID: IJSRDV8I10567 Published in: Volume : 8, Issue : 1 Publication Date: 01/04/2020 Page(s): 1264-1267 |
Article Preview |
|
|
|
|
